Parent Category: Manual & FAQs
Category: 05 ContaCam Networking

connect to rtsp


1. Camera IP or Hostname or URL

  1. Some cameras are supplied with an installation CD, run the setup and if possible set a static IP for your camera.
  2. If there is no installation software then run a network scanner, for example there are the free Advanced IP Scanner or Wireless Network Watcher. After installing one of those programs on your PC, run it to find the camera IP by looking at the Manufacturer or Company column.
  3. If your camera only supports dynamic IP assignment through DHCP then either use the network name instead of the IP address or instruct your router / modem to always assign the same IP to your camera. To achieve that enter your router / modem web interface and search the network connections section which permits the management of the assigned IP:

Assign same ip


2. Camera Port, Maker and Protocol

  1. Always remember to set the correct Camera Port, for RTSP that's usually 554 and for HTTP it's 80.
  2. If your camera is not listed under Camera Maker and Protocol try all the Generic possibilities.
  3. If also those Generic choices are not working then search the stream address (as URL).
    • In your camera documentation or on the producer homepage.
    • Try also this great source of information.
    • Install and run the free ONVIF Device Manager, Log in providing your camera credentials. Press Refresh, select your camera and click the Live video link. Now copy the URL shown under the live video and paste it into ContaCam's Camera - Network / IP Camera dialog under Camera IP or Hostname or URL:

Onvif device manager

Connect to onvif


3. Camera Instability or Stream Corruption

Stream corruptionSmearingArtifactsExtreme smearing

If a network camera keeps restarting displaying from time to time the Cannot connect to camera message or if the video stream shows smearing or other artifacts, then follow the below steps.

For all cameras

For all WiFi cameras

For RTSP cameras (especially if connected through WiFi)

Connect to rtsp tcp